HP Designjet 10000s Printer series - Manual (Page 113)

13. Loosen the sub-scroller flanges (1) and adjust the media roll position on the sub-scroller so that there
is more than 4 cm clearance (A) between the two media rolls.
CAUTION If there is less than 4 cm of clearance between the two media rolls, the edge
guards cannot be used. Without the edge guards the media edges could rise and cause a
printhead crash.
14. Install the sub-scroller tension arm (1) removed previously.
ENWW Install dual media rolls on separate scrollers 103
How do
I use dual medi
a
rolls?