Heater error messages – HP Designjet 10000s Printer series User Manual
Page 317
No.
Item
Item display
(upper line)
Parameters
display (lower
line)
Description
Initial value
2
Heat suspending
time after printing
DELAY TIME
00 to 30 MINUTES
UNIT: minute
05 MINUTES
3
Standby heating
time after
completion of
DELAY TIME
STANDBY TIME
0, 30, 60, 90, 120,
ENDLESS
Unit: minutes
30
4
Version display
VERSION
FW=vv.r HW=vv.r
Display only
–
5
Diagnostics
DIAGNOSTICS
NO, YES
NO: Does not
perform the
diagnostics.
YES: Performs the
diagnostics.
NO
6
Display language
LANGUAGE
ENGLISH
JAPANESE
–
ENGLISH
7
Exit setup mode
EXIT
YES, NO
YES: Exits the
parameter setup
mode.
NO: Does not exit
the parameter
setup mode.
YES
*1 Display only, ON/OFF key is ignored.
Heater error messages
When the following error messages are displayed on the heater front panel, contact HP Support.
●
System error
●
The relay board cannot be detected
●
Front heater thermistor temperature error (-10 °C or less, 70 °C or more)
ENWW
Heater error messages
307
Te
ll me about t
h
e heaters