HP Designjet 10000s Printer series - Manual (Page 295)

Parameters:
● SOFTWARE — Settings in the RIP take priority.
● FRONT PANEL — Settings in the printer front panel take priority.
Heater preference (HEATER PREF)
Use this option to define printer front panel priority or software RIP priority for heater settings for the selected
media type. If you select software RIP priority, the printer will ignore heater settings that are defined on the
printer and heater front panels and use the settings from the RIP.
Parameters:
● SOFTWARE — Settings in the RIP take priority.
● HEAT PANEL — Settings in the printer front panel take priority.
Media width detection (WIDTH DETECTION)
Use this option to define the media width detection method.
Parameters:
● AUTOMATIC — The normal mode using the line sensor.
● RIGHT ONLY — Only detect the right edge side.
● NONE — Do not detect the media edge.
Media width (MEDIA WIDTH)
Use this option to define the media width when the WIDTH DETECTION is set to a manual setting (RIGHT
ONLY or NONE).
Parameters: value in mm
Liner width (LINER WIDTH)
Use this option to define the liner width for the vacuum fan.
ENWW The MEDIA REG menu 285
Tell m
e ab
ou
t f
ro
n
t
p
anel
m
enu
s