HP Designjet 10000s Printer series - Manual (Page 76)

To change the printhead height on the front panel:
1. Press the Online key.
2. Press the key to display the MEDIA REG menu.
3. Scroll to the PH HEIGHT VAL option and press the OK key.
4. Select NORMAL or HIGH, according to the mechanical change you have made, and press the OK
key.
Parameters: NORMAL (default) or HIGH (for thick media).
NOTE When the printhead height is changed, a gap in printing may occur in bidirectional
printing. Adjust the correction value for bidirectional printing (Refer to Perform printhead position
adjustment ).
Remove a media roll from the printer
To remove a media roll from the printer:
1. Remove the tension bars from the media feed side and take-up side of the printer.
2. If necessary, cut the media.
CAUTION A mesh is installed on the media feed side and take-up side of the printer so
that the media does not adhere to the platen. Do not remove this netting. When cutting the
media, take care not to damage the netting.
66 Chapter 2 How do I perform basic media operations? ENWW
How
do
I p
erf
or
m b
asic m
edia
o
p
erat
ions?