HP Designjet 10000s Printer series User Manual
Page 66
Advertising
19.
At the wiper end of the tension bar (1), adjust the take-up bar flange (3) position for the width of the
media, leaving a 2 mm gap, and lock it in position with the two O-rings (2).
20.
At the capping end, adjust the take-up flange (1) on the tension bar (2) so it is positioned against the
edge of the media (without the fixing O-rings).
21.
At the rear of the printer, set the white media winding direction switch (1) to the correct position for
the direction the media is to be taken-up, inner take-up (A) or outer take-up (B).
56
Chapter 2 How do I perform basic media operations?
ENWW
How
do
I p
erf
or
m b
asic m
edia
o
p
erat
ions?
Advertising