HP Designjet 10000s Printer series User Manual
Page 211
21.
Install an ink system purging cartridge in to each slot and close the right ink cartridge door.
NOTE
If the printer detects that an ink system purging cartridge has been installed
incorrectly or if an invalid cartridge has been installed, a warning message will be displayed
on the front panel. You will need to make sure that a valid ink system purging cartridge has
been installed correctly before you can continue.
22.
The extraction process starts and you need to recheck whether the waste ink bottle is present and
is not full. Press the
OK
key once the waste ink bottle has been checked.
23.
When prompted by the front panel, open the left ink cartridge door and remove all three ink system
purging cartridges.
24.
Install a used storage liquid cartridge in to each slot and close the left ink cartridge door.
NOTE
If the printer detects that a purging liquid cartridge has been installed incorrectly,
or if any of the purging liquid cartridges contain less than 350 cc of liquid, or if an invalid
purging liquid cartridge has been installed, a warning message will be displayed on the front
panel.
You will need to make sure that a valid purging liquid cartridge has been installed correctly
before you can continue.
25.
When prompted by the front panel, open the right ink cartridge door and remove all three ink system
purging cartridges.
26.
Install a used purging liquid cartridge in to each slot and close the right ink cartridge door.
NOTE
If the printer detects that a storage liquid cartridge has been installed incorrectly,
or if any of the storage liquid cartridges contain less than 350 cc of liquid, or if an invalid
storage liquid cartridge has been installed, a warning message will be displayed on the front
panel.
You will need to make sure that a valid storage liquid cartridge has been installed correctly
before you can continue.
27.
The charge process starts and you need to recheck whether the waste ink bottle is present and is
not full. Press the
OK
key once the waste ink bottle has been checked.
28.
Once the ink system storage process has been completed, the front panel will return to the STORE
INK SYS menu.
29.
You can now turn the printer off.
When you start to use your printer again you will first have to carry out the processes described in
Clean
ink system
and
Charge the ink system
.
ENWW
Prepare for extended power down (two to four weeks)
201
How do
I mai
n
tai
n
the
er?