HP Designjet 10000s Printer series - Manual (Page 146)

a. Select the media type using the or keys.
b. Press the OK key to confirm the selection.
19. Select whether or not a liner is used.
a. Select liner use requirement using the or keys. If a liner is used.
b. Press the OK key to confirm the selection.
20. At the front of the printer, use the black media advance switch to loosen the media enough to be able
to install a tension bar (2) of approximately half the media width in the slack area of the media (1).
The media setting operation starts automatically.
Verify the front panel shows this message and press the OK key.
NOTE The next operation will not start if the media is too tight.
136 Chapter 4 How do I perform double-sided printing ENWW
How
do
I per
fo
rm
do
ub
le-si
d
ed
p
rint
in
g