HP Designjet 10000s Printer series - Manual (Page 127)

4. Use adhesive tape (2) to attach the edge of each roll media (3) to the media tube on the take-up reel
(1).
5. Verify that the tension bar guide (1) is located within the light sensor (2) receiving area and adjust as
necessary.
6. Set the take-up direction switch (1) to the correct position for the direction the media is to be taken-
up, inner take-up (A) or outer take-up (B).
ENWW Use the take-up reel (dual media rolls) 117
How do
I use dual medi
a
rolls?