HP Designjet 10000s Printer series - Manual (Page 147)

If the operation finishes successfully, the printer returns to the online or offline state.
If it terminates unsuccessfully, an error message will be shown. If this occurs, retry the operation from
the step in this procedure where you raised the media load lever.
21. Set the “VACUUM” and “UNSTICK MODE” values with the front panel according to the type of media
you are using. Refer to
Unstick mode (UNSTICK MODE) .
NOTE It is recommended to perform a normal printhead recovery before starting to print
on the back of the media. Refer to Normal printhead recovery .
22. Print on the back of the media.
NOTE The output image from the RIP does NOT need to be rotated.
ENWW Printing on the back of the media after rewinding 137
How
do
I per
for
m
do
ub
le-sid
ed
p
rint
in
g