Tension bars – HP Designjet 10000s Printer series User Manual
Page 68
2.
Press the key to see MEDIA REG menu options.
3.
Select the media with which you want to use or not use the media edge guards, and press the
OK
key.
This setting will only apply to the selected media.
4.
Scroll to USE EDGE GUARD using the or keys and press the
OK
key.
5.
Select YES or NO and press
OK
to confirm.
Tension bars
You use the same tension bars on the media feed side and take-up side of the printer but in order to
eliminate the possible of the build up of any electrostatic energy different flanges are used for each. The
tension bars are provided in three sets, two with flanges and one without flanges providing the following
total parts:
●
3 x long tension (1) bar with male joints at each end (123 cm)
●
3 x medium tension (2) bar with one male and one female joint (61 cm)
●
6 x short tension bars (3) with one male and one female joint (41 cm)
●
6 x standard flanges (4)
●
2 x take-up flanges (5)
●
2 x fixing rings (6)
●
1 x feed side ESD contact ring (7)
●
1 x take-up side ESD flange (8)
58
Chapter 2 How do I perform basic media operations?
ENWW
How
do
I p
erf
or
m b
asic m
edia
o
p
erat
ions?