HP Designjet 10000s Printer series - Manual (Page 316)

Front heater Print heater Rear heater
Preset temperature AAA BBB CCC
Current temperature XXX YYY ZZZ
U stands for the temperature unit: C (Celsius) or F (Fahrenheit).
The temperature is measured every 5 seconds and refreshed.
Display — heater on
When each heater is heated, a plus sign (+) is displayed in place of the unit of each heater current
temperature on the second line. The unit display is restored at the completion of heating. In the display
example shown above, the front heater is heated.
Display — heater off
OFF is displayed in the setup temperature display area of the heater that is turned off. The temperature
unit of the heater that is turned off is not displayed. The current temperature area is displayed as it is.
Display — heater AC power is turned off
TURN ON HEATER POWER SWITCH is displayed on the front panel.
Heater parameter setup mode
This mode is used when the operator sets the heater control system parameters.
Setup items and parameters
The setup items and parameters are listed in the table below.
No. Item Item display
(upper line) Parameters
display (lower
line) Description Initial value
1 Temperature unit UNIT CELSIUS
FAHRENHEIT
– CELSIUS
306 Chapter 15 Tell me about the heaters ENWW
Tell
me about
the heat
ers