HP Designjet 10000s Printer series - Manual (Page 302)

Cap cleaning (CAP CLEANING)
Use this option to move the printhead carriage to the wiper position so that you can clean the capping unit
manually.
Parameters: none.
Wiper cleaning (WIPER CLEANING)
Use this option to lift the wiper blade so that you can clean the wiper blade manually.
Parameters: none.
Washing with printheads (WASH PRINTHEADS)
Use this option to fill the cap with ink to soak the printhead (nozzle surface) in the ink for a minimum of 1
to 2 hours to remove nozzle clogging. If possible, leave the printer overnight.
Use this option when nozzles cannot be fixed by cleaning repeatedly.
Parameters: none.
NOTE Always perform Cleaning (normal) after filling the cap.
If the printhead surface is not clean even after leaving the printer overnight, then contact HP
Support.
Printhead height (PH HEIGHT ADJ)
Use this menu option to adjust the printhead height.
The cap is opened after performing this operation and the carriage height can be adjusted, see Change
the printhead height .
Parameters: none.
292 Chapter 14 Tell me about front panel menus ENWW
Tell
me ab
ou
t f
ron
t
pan
el
menu
s