HP Designjet 10000s Printer series User Manual
Page 149
3.
Feed the media onto the take-up reel (Refer to
Use the take-up reel
).
NOTE
Wind the media onto the take-up reel about four full turns because you will need a
top margin of approximately 2.5 m to print on the back of the media.
4.
Print on the top side of the media.
5.
When the printing on the top side completes, two additional lines are printed. The first is a solid line
(2) which is used as a guide to align the print position between the top side and the back; the second
line is a dashed line (1) to use as a cutting guideline.
6.
Once the printing has completed, feed enough media out of the printer and cut the media along the
dashed line.
7.
With a suitable marker put guide marks (2) on the edges of the back of the media (3), where the edges
are intersected by the solid line (1).
ENWW
Printing on the back of the media from the feed side (after relocating from take-up
side)
139
How
do
I per
for
m
do
ub
le-sid
ed
p
rint
in
g