HP Designjet 10000s Printer series - Manual (Page 36)

● Use only an HP waste ink bottle. The bottle must be installed according to instructions or waste ink
may overflow. An HP waste ink bottle must always be installed before turning the printer ON. Automatic
and manual service cycles produce waste ink that must be contained in an HP waste ink bottle. Do
not remove the cap from its tether to the HP waste ink bottle. The cap is needed to properly seal the
HP waste ink bottle for disposal. Keep the HP waste ink bottle upright. Do not place on tables or
shelves where it could fall. Waste ink is combustible. Keep an HP waste ink bottle containing waste
ink away from open flames, sparks, or other sources of ignition. The level in the HP waste ink bottle
must be checked by visual inspection to prevent overflow. If the waste ink level is above the indication
line, the bottle must be replaced with an empty HP waste ink bottle.
● Place a sheet of paper under the HP waste ink bottle on the floor when removing a bottle containing
waste ink. This will help clean up any ink spills. If soaked with ink, treat the paper as a combustible
material and dispose of properly.
● Do not store HP ink cartridges in direct sunlight. Store HP ink cartridges in a cool, dry place. This
prevents deterioration of the ink during storage.
26 Chapter 1 Introduction ENWW
Int
rod
uct
ion