HP Designjet 10000s Printer series - Manual (Page 132)

Dual media rolls take-up method 3
This procedure describes how to take-up two vinyl chloride (PVC) media rolls onto a single media tube.
1. Put a suitable empty media tube and rubber spacers (1) on the main scroller (Refer to Use media tube
flanges ).
2. Install the four media tube flanges (1) on the rubber spacers at the both ends and in the center of the
media tube.
3. At the rear of the printer, set the white media winding direction switch (1) to the OFF position.
122 Chapter 3 How do I use dual media rolls? ENWW
How
do I use dua
l media roll
s?