HP Designjet 10000s Printer series User Manual
Page 75
Advertising
5.
Open the cap cover (3) and loosen the printhead fixing screws (1) using the long screwdriver provided
with your printer inserted through the hole in the chassis (2).
6.
Change the height of the printhead by lifting the printhead height lever (1) to lower the printhead, or
by lowering it to lift the printhead.
7.
Tighten the printhead fixing screws, previously loosened, using the long screwdriver provided with
your printer.
NOTE
Tighten the printhead fixing screws while applying slight downward pressure on the
carriage using your hand.
8.
Close the rear cover.
ENWW
Change the printhead height
65
How
do
I p
erf
or
m
b
asic m
edi
a
o
p
erat
ions?
Advertising