HP Designjet 10000s Printer series User Manual
Page 49
b.
At the front of the printer, use the black media advance switch to feed enough media so that you
can install the tension bar (1) in the slack area of the media.
NOTE
Make sure the tension bar (1) is positioned in the center (widthwise) of the
slack area of the media or the media may not feed smoothly .
NOTE
If the media does not roll out smoothly, adjust the tension bar (1) length to be
a little shorter than the width of the media.
18.
Install another tension bar (fixing bar) in the tension bar guide at the front of the printer (feed side).
NOTE
Refer to
Tension bars
for full details concerning the adjustment of the tension bar
(fixing bar) length.
a.
Adjust the tension bar (1) length to match the width of the media.
b.
Fit flanges to each end of the tension bar.
c.
Verify that the tension bar guide (2) is located at the correct position for the actual width of the
tension bar and adjust as necessary.
ENWW
Install a media roll in the printer using the main scroller
39
How
do
I p
erf
or
m
b
asic m
edi
a
o
p
erat
ions?