HP Designjet 10000s Printer series - Manual (Page 287)

Dry time value (DRY TIME VALUE)
Use this option to define the amount of time the printhead carriage pauses between printing passes for the
selected media type.
Parameters: three-digit time in seconds.
Print mode setting (PRINT MODE)
Use this option to set the default print quality for the selected media type.
NOTE This value will only be applied by the printer front panel setting if the PRINT MODE
PREF option is set to FRONT PANEL.
Parameters:
● NORMAL (4-pass)
● H-QUALITY (8-pass)
● H-DENSITY (8-pass)
● 3 TIMES (12-pass)
● H-QUALITY2 (16-pass)
● H-DENSITY2(16-pass)
● DRAFT (2-pass)
● FAST (4-pass)
● F-H-QUALITY (8-pass)
● F-H-DENSITY (8-pass)
● F-3 TIMES (12-pass)
● F-H-QUAL2 (16-pass)
● F-H-DENS2 (16-pass)
● FINE DRAFT (4-pass)
Print direction setting (PRINT DIRECTION)
For the selected media type, use this option to set bidirectional printing so that the print carriage places ink
on the media at every pass, or unidirectional printing so that the print carriage places ink on the media once
every two passes.
ENWW The MEDIA REG menu 277
Tell m
e ab
ou
t f
ro
n
t
p
anel
m
enu
s