HP Designjet 10000s Printer series - Manual (Page 125)

14. Verify the front panel shows this message and press the OK key.
NOTE The next operation will not start if the media is too tight.
The media setting operation starts automatically and shows this message on the front panel.
If the operation completes correctly, the printer returns to the online or offline state.
If it does not complete correctly, the front panel will show an error message. If this occurs, retry the
operation from the step in this procedure where you raised the media load lever.
15. Only take-up methods 1 or 3” can be used when using this dual roll printing process (Refer to Use the
take-up reel (dual media rolls) ).
ENWW Install dual media rolls on the main scroller 115
How do
I use dual medi
a
rolls?