HP Designjet 10000s Printer series - Manual (Page 159)

10. Feed the printed media (1) edge towards the feeder over the top surface of the sub-scroller, and insert
it into the feeder.
11. Adjust the media so that the marks (2) that you made earlier are aligned with the groove (1) in the
platen. If they do not align with platen groove at both sides, align either end first, and then while holding
the aligned side in place, pull the other side to adjust its position.
ENWW Printing on the back of the media from the take-up reel (without relocating from take-
up side)
149
How
do
I per
for
m
do
ub
le-sid
ed
p
rint
in
g