HP Designjet 10000s Printer series - Manual (Page 294)

NOTE When the TENSION winding or BACK & FWD (MEDIA ADV MODE mode) is selected,
the printer will only use START & END even if you have selected DURING PRINT.
When you select DURING PRINT and cleaning has interrupted printing of an image, the media
will feed back so that the image that was being printed before cleaning started, can be continued.
The amount of back feed can be set through the BACK ADJUST VAL option.
Media back feed adjustment (BACK ADJUST VAL)
This option sets the amount of back feed when printing of an image is interrupted by the automatic cleaning
process.
Set a back feed adjustment value for the media based on the back feed adjustment pattern (Refer to
Calibrate the printer ).
Parameters: ±2000 pulses (+5 mm), 1 pulse=2.5 µm
Tip After printing the back feed adjustment pattern, measure the start distance. Try setting the
value at 0005 and reprint the back feed adjustment pattern and re-measure the distance and
modify the value if necessary. Increasing the value will increase the distance.
Media advance preference (ADVANCE PREF)
Use this option to define printer front panel priority or software RIP priority for media advance settings for
the selected media type. If you select software RIP priority, the printer will ignore media advance settings
that are defined on the printer front panel and use the settings from the RIP.
Parameters:
● SOFTWARE — Settings in the RIP takes priority.
● FRONT PANEL — Settings in the printer front panel take priority.
Print mode preference (PRINT MODE PREF)
Use this option to define printer front panel priority or software RIP priority for print mode settings for the
selected media type. If you select software RIP priority, the printer will ignore print mode settings that are
defined on the printer front panel and use the settings from the RIP.
284 Chapter 14 Tell me about front panel menus ENWW
Tell
me ab
ou
t f
ron
t
pan
el
menu
s