HP Designjet 10000s Printer series - Manual (Page 238)

● F-3 TIMES — fast high extra high density print mode
● F-H-QUAL2 — fast half speed high quality print mode
● F-H-DENS2 — fast half speed high density print mode
● FINE DRAFT — fine draft print mode
Back feed adjustment while printing
This option allows you to adjust how much back feed is applied to a media while you are printing.
1. Press the key or key when “PRINTING” is displayed on the front panel.
2. Use the and keys to change the current feed correction value in 0.01% increments. The value
displayed on the second line of the display is applied immediately to the current print job. After three
second of no key activity the display is returned to the original display
NOTE The correction value at the start of printing is shown on the first line, this will not
change until printing finishes. If cleaning is executed in cleaning mode 2 during printing, the
correction value changed during cleaning is displayed after cleaning finishes.
228 Chapter 7 How do I get the best image quality? ENWW
How do
I get the
best
image
q
ualit
y?