HP Designjet 10000s Printer series - Manual (Page 233)

Calibrate the printer
You can adjust the mechanical and electrical settings of your printer based on a series of printed patterns.
These patterns allow you to calibrate your printer settings for the media you are using. Based on the results
of these patterns, you can optimize the performance of your printer.
Calibrate media advance
Your printer was calibrated at the factory to ensure that it advances the media accurately when using
supported media types in normal environmental conditions. However, you may find it useful to re-calibrate
in certain circumstances:
● Unsupported media: different media manufacturers provide media with a wide range of properties
such as thickness or stiffness, which may benefit from calibration. You can expect the best print quality
when using HP's recommended media.
● Abnormal but stable environmental conditions: if you are printing in unusual conditions of temperature
or humidity and those conditions are expected to remain stable, re-calibration may be worthwhile.
However, media advance calibration assumes that you have an image quality problem and that you have
already followed the appropriate troubleshooting procedure for that problem. If you have no particular
problem, there is no need to perform the calibration.
NOTE This procedure describes media advance calibration for all media loaded in the printer.
If you need to calibrate media advance for a specific media only, then define advance using
the MEDIA REG option.
1. Load media widths larger than A1 size and longer than 1 m.
NOTE If you intend to use TENSION winding on the take-up reel, set media advance in
tension winding mode.
Longer print length is required in the tension winding mode.
2. Press the Online key.
3. Select M_ADV using the ► key.
Select MEDIA ADV PRINT and press OK .
Select the print mode you usually use for the media you are calibrating.
Selectable print modes are NORMAL, H-QUALITY, H-QUALITY2, H-DENSITY, H-DENSITY2, and
DRAFT.
Select the NORMAL media feed adjustment pattern if adjusting the high speed mode.
ENWW Calibrate the printer 223
How do I
get
the best image
q
uali
ty
?