HP Designjet 10000s Printer series - Manual (Page 156)

1. Install the media on the main scroller in the printer (Refer to Install a media roll in the printer using the
main scroller ).
2. Select the media feed position.
a. Select FRONT using the or keys.
b. Press the OK key to confirm the selection.
CAUTION To print on thick tarpaulin (0.5 mm or thicker), raise the printhead height
first (Refer to Change the printhead height ).
NOTE If tarpaulin media designed for single side printing (different surface finishes)
is used, print on the rougher side first.
When the media feed position is set to FRONT, two additional lines are printed at the
end of the print job to aid the alignment of the media when it is reloaded to print on the
other side. To ensure these lines are printed in the correct position, make sure all the
print jobs for the top side of the media are sent immediately from the print application.
3. Feed the media onto the take-up reel (Refer to Use the take-up reel ).
NOTE Wind the media onto the take-up reel about four full turns because you will need a
top margin of approximately 2.5 m to print on the back of the media.
4. Print on the top side of the media.
146 Chapter 4 How do I perform double-sided printing ENWW
How
do
I per
fo
rm
do
ub
le-si
d
ed
p
rint
in
g