HP Designjet 10000s Printer series - Manual (Page 52)

Install a media roll in the printer using the sub-scroller
CAUTION Do not touch heater surfaces in the paper path. This may cause burns.
Handle media rolls with care. They can be heavy and difficult to move in confined spaces. In some
cases, two people should move and install media rolls. Dropping a media roll could cause
personal injury or damage to the printer.
The printer's front panel messages will guide you through the process of loading media. To install a media
roll in the printer on the sub-scroller:
1. Place the media roll on a suitable table.
2. Install the media roll on the sub-scroller.
a. Verify the media winding direction for the side of the media you are going to print onto, either the
inside of the media (2) or the outside of the media (1).
b. Carefully slide the media tube (2) onto the sub-scroller (1).
42 Chapter 2 How do I perform basic media operations? ENWW
How
do
I p
erf
or
m b
asic m
edia
o
p
erat
ions?