Ink system storage – HP Designjet 10000s Printer series User Manual
Page 209
WARNING!
Never leave the printer off for more than four weeks. Leaving your printer off for
more than four weeks can cause permanent damage that cannot be repaired. In all other cases
make sure you observe the appropriate maintenance guidelines.
Have available an empty waste ink bottle and the HP 790 Ink System Storage Kit (part number CB297A).
This kit includes:
●
Six ink system purging cartridges
●
Six ink system storage liquid cartridges
Ink system storage
This procedure allows you to empty the ink system of ink and fills it with storage liquid that will preserve
the ink system if you do not intend to use the printer for a period of time (two to four weeks).
CAUTION
Do not open or close the rear covers or change the position of levers while the ink
system storage process is being performed, or the operation may have to be restarted from the
beginning. This will result in waste of the storage liquid. If the ink system storage process has to
be restarted, new storage liquid cartridges will be needed (i.e. a new HP 790 Ink System Storage
Kit).
1.
Press the ONLINE key.
2.
Press the
SHIFT
key to display the PH. MAIN menu.
3.
Press the key to select the PH. MAIN menu and press
OK
.
4.
Press the or keys to select the STORE INK SYS option and press OK.
5.
When the front panel displays the waste ink bottle warning message, check whether the waste ink
bottle is present and make sure it is empty.
CAUTION
This process will produce over 3 liters of waste liquid so the waste ink bottle
must be empty.
6.
Press the
OK
key once the waste ink bottle has been checked.
7.
Open the left ink cartridge door and remove all three ink cartridges.
8.
Install an ink system purging cartridge in to each slot and close the left ink cartridge door.
NOTE
If the printer detects that an ink system purging cartridge has been installed
incorrectly or if an invalid cartridge has been installed, a warning message will be displayed
on the front panel. You will need to make sure that a valid ink system purging cartridge has
been installed correctly before you can continue.
9.
Open the right ink cartridge door and remove all three ink cartridges.
10.
Install an ink system purging cartridge in to each slot and close the right ink cartridge door.
ENWW
Prepare for extended power down (two to four weeks)
199
How do
I mai
n
tai
n
the
er?