HP Designjet 10000s Printer series - Manual (Page 32)

10. “F-H-DENSITY” (Reduced PC processing time + High density printing — 8–pass) This mode provides
equivalent density and print speed to the H-DENSITY mode.
11. “F-3 TIMES” (Reduced PC processing time + High density printing — 12–pass) This mode provides
equivalent density and print speed to the 3–TIMES mode.
12. “F-H-QUAL2” (Reduced PC processing time — 16–pass) This mode is used for media that has poor
drying performance or shows noticeable uneven printing in F-H-QUALITY mode. The print speed is
half the speed of the F-H-QUALITY mode.
13. “F-H-DENS2” (Reduced PC processing time + High density printing — 16–pass) This mode provides
equivalent density to the H-DENSITY mode but at half the speed.
14. “FINE DRAFT” (Productivity + Image quality oriented — 4–pass) This mode provides a print resolution
of 540 x 720 dpi at a print speed of 20 m2/h which is 20% faster than the NORMAL mode. The image
quality for photographs is almost equivalent to that of the NORMAL mode, but a solid image of 100%
density is printed at 75% density of the NORMAL mode. Consequently, if the darkness of the colors
is important, you should use the NORMAL mode.
Safety precautions
The following symbols are used in this manual to ensure the proper use of the printer and to prevent the
printer from being damaged. Follow the instructions marked with these symbols.
WARNING! Failure to follow the guidelines marked with this symbol could result in serious
personal injury or death.
CAUTION Failure to follow the guidelines marked with this symbol could result in minor personal
injury or damage to the product.
General warnings
● Only use a 200-240 V AC power supply voltage. Avoid overloading the printer’s electrical outlet with
multiple devices.
● Be sure the printer is well-grounded. Failure to ground the printer may result in electrical shock, fire,
and susceptibility to electromagnetic interference.
● Do not disassemble or repair the printer yourself. Do not reinstall the printer in a new location. Call
your local HP Service Representative for service.
● Use only the electrical cord supplied by HP with the printer. Do not damage, cut, or repair the power
cord. A damaged power cord has risk of fire and electric shock. Replace a damaged power cord with
an HP-approved power cord.
● Do not allow metal or liquids (except those used in HP Cleaning Kits) to touch the internal parts of the
printer. Doing so may cause fire, electric shock, or other serious hazards.
● Power OFF the printer and unplug the power cable from the power outlet in any of the following cases:
● When placing your hands inside the printer.
● If there is smoke or an unusual smell coming from the printer.
22 Chapter 1 Introduction ENWW
Int
rod
uct
ion