Install the separator bar support assembly – HP Designjet 10000s Printer series User Manual
Page 194
Advertising
●
2 x separator bar holders (4)
Install the separator bar support assembly
This procedure describes how to install the separator bar support assembly.
1.
Locate the separator bar support assembly installation kit supplied with your printer.
2.
Remove and retain the attachment screws (1) and (3) from the printer chassis on the take-up side
(wiper end). Discard the hole cover (2).
184
Chapter 5 How do I print with a liner
ENWW
How do
I print with a liner
Advertising