Rockwell Automation 2198-Hxxx Kinetix 5500 Servo Drives User Manual - Manual (Page 83)

Rockwell Automation Publication 2198-UM001D-EN-P - May 2014 83
Connecting the Kinetix 5500 Drive System Chapter 5
Motor Feedback Connections
Single motor cable feedback connections are made by using the
2198-KITCON-DSL feedback connector kit.
Figure 48 - MF Connector Wiring
Table 40 - Motor Feedback (MF) Connector Specifications
IMPORTANT When using the 2198-KITCON-DSL feedback connector kit, the ambient
temperature for the Kinetix 5500 drive enclosure is 0…50 °C (32…122 °F).
Motor Cable
Shield Clamp
Motor Feedback
Connector Kit 2198-KITCON-DSL
Feedback Connector Kit
Connector
Housing
Refer to Kinetix 5500 Feedback Connector
Kit Installation Instructions, publication
2198-IN002 , for connector kit specifications.
Internal
Grounding Plate
Clamp Screws (2)
Mounting Screws (2)
Exposed Shield
Feedback Cable
(EPWR+, EPWR-)
Cover
Kinetix 5500 Servo Drive
(front view)
2090-CSxM1DF-18AAxx
Motor Cable
IMPORTANT Cable preparation and positioning that provides a high-frequency bond
between the shield braid and grounding plate is required to optimize
system performance.
Drive Cat. No. Pin
Signal/
Wire Color Wire Size
AWG Strip Length
mm (in.) Torque Value
N•m (lb•in)
2198-Hxxx-ERSx
MF-1 D+/Blue
22 10.0 (0.39) 0.4 (3.5)
MF-2 D-/White/Blue
IMPORTANT The feedback bundle in 2090-CSxM1DF-18AAxx motor cables (typically used
with frame 1 drives) route around the shield clamp (as shown in
Figure 48 ).
The feedback bundle in 14 and 10 AWG cables (typically used with frame 2
and 3 drives) route with the power and brake wires inside the cable shield.