Dell PowerEdge FX2/FX2s - Manual (Page 105)

Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
To clear ETS TLV counters, use the clear ets counters interface port-
type slot/port command.
The following describes the show interface summary command shown in the
following example.
Field Description
Interface Interface type with stack-unit and port number.
Max Supported
TC Group Maximum number of priority groups supported.
Number of Traffic
Classes Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off. When on, the scheduling and
bandwidth allocation configured in an ETS output policy or
received in a DCBX TLV from a peer can take effect on an
interface.
Admin Parameters ETS configuration on local port, including priority groups,
assigned dot1p priorities, and bandwidth allocation.
Remote
Parameters ETS configuration on remote peer port, including admin
mode (enabled if a valid TLV was received or disabled),
priority groups, assigned dot1p priorities, and bandwidth
allocation. If ETS admin mode is enabled on the remote port
for DCBX exchange, the Willing bit received in ETS TLVs
from the remote peer is included.
Local Parameters ETS configuration on local port, including admin mode
(enabled when a valid TLV is received from a peer), priority
groups, assigned dot1p priorities, and bandwidth allocation.
Operational status
(local port) Port state for current operational ETS configuration:
• Init: Local ETS configuration parameters were
exchanged with the peer.
• Recommend: Remote ETS configuration parameters were
received from the peer.
• Internally propagated: ETS configuration
parameters were received from the configuration
source.
ETS DCBX Oper
status Operational status of the ETS configuration on the local
port: match or mismatch.
105