Dell PowerEdge FX2/FX2s - Manual (Page 256)

stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax stack-unit 0-5 renumber 0-5
Parameters
0-5 The first instance of this value is the stack member unit
identifier, from 0 to 5, of the switch that you want add to the
stack. The range is from 0 to 5. The second instance of this
value is the desired new unit identifier number.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators.
You can renumber any switch, including the management unit or a stand-alone
unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the
members are renumbered, only that specific unit is reset and comes up with the
new unit number.
Example
Dell#stack-unit 5 renumber 4
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
• reload – reboots Dell Networking Operating System (OS).
• reset stack-unit – resets the designated S-Series stack member.
• show system – displays the current status of all stack members or a specific
member.
256