Dell PowerEdge FX2/FX2s - Manual (Page 333)

checksum
runtime 1-0(0-1862) Control Processor
passed
CPLD IMAGE INFORMATION :
---------------------------------------------------------------
------
Card CPLD Name Version
Stack-unit 0 IOM SYSTEM CPLD 7
Dell#
show running-config
Displays the current configuration and display changes from the default values.
Syntax show running-config [entity] [configured] [status]
Parameters
entity (OPTIONAL) To display that entity’s current (non-default)
configuration, enter one of the following keywords:
NOTE: If you did not configure anything for that entity,
nothing displays and the prompt returns.
boot for the current boot configuration
ftp for the current FTP configuration
igmp for the current IGMP configuration
interface for the current interface configuration
line for the current line configuration
lldp for the current lldp configuration
logging for the current logging configuration
management-
route for the current Management port
forwarding configuration
monitor for the current Monitor configuration
snmp for the current SNMP configuration
uplink-
state-group for the uplink state group
configuration
users for the current users configuration
configured (OPTIONAL) Enter the keyword configured to display line
card interfaces with non-default configurations only.
status (OPTIONAL) Enter the keyword status to display the
checksum for the running configuration and the start-up
configuration.
Command
Modes EXEC Privilege
333