Dell PowerEdge FX2/FX2s - Manual (Page 115)

Parameters
interface type
slot/port
• For the management interface on the stack-unit, enter
the keyword management ethernet followed by slot/port
information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command
Modes EXEC Privilege
Default None
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
When you enter the release dhcp command, although the IP address that was
dynamically-acquired from a DHCP server is released from an interface, the ability
to acquire a new DHCP server-assigned address remains in the running
configuration for the interface. To acquire a new IP address, enter either the renew
dhcp command at the EXEC privilege level or the ip address dhcp command at
the interface configuration level.
renew dhcp interface
Re-acquire a dynamic IP address on an Ethernet interface enabled as a DHCP client.
Syntax renew dhcp interface type slot/port}
Parameters
interface type
slot/port Enter any of the following keywords and slot/port or number
to clear counters from a specified interface:
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command
Modes EXEC Privilege
Default None.
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
information
The renew dhcp command is used to renew the lease of IP address obtained
through dhcp.
115