Dell PowerEdge FX2/FX2s - Manual (Page 324)

• To copy the running configuration, enter the keywords
running-config.
• To copy the startup configuration, enter the keywords
startup-config.
• To copy a file on the external FLASH, enter usbflash://
then the filename.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
The Dell Networking OS supports a maximum of 100 files, at the root directory
level, on both the internal and external Flash.
The usbflash commands are supported. For a list of approved USB vendors, refer
to the Dell Networking OS Release Notes.
When copying a file to a remote location (for example, using Secure Copy [SCP]),
enter only the keywords and Dell Networking OS prompts you for the rest of the
information.
For example, when using SCP, you can enter the copy running-config scp:
command. The running-config is the source and the target is specified in the
ensuing prompts. Dell Networking OS prompts you to enter any required
information, as needed for the named destination — remote destination,
destination filename, user ID and password, and so forth.
When you use the copy running-config startup-config command to copy
the running configuration (the startup configuration file amended by any
configuration changes made because the system was started) to the startup
configuration file, Dell Networking OS creates a backup file on the internal flash of
the startup configuration.
The Dell Networking OS supports copying the running-configuration to a TFTP
server or to an FTP server:
• copy running-config tftp:
• copy running-config ftp:
In the copy scp: flash: example, specifying SCP in the first position indicates
that the target to specify in the ensuing prompts. Entering flash: in the second
position means that the target is the internal Flash. In this example, the source is on
a secure server running SSH, so you are prompted for the UDP port of the SSH
server on the remote host.
Example
(running-
config scp:)
Dell#copy running-config scp:
Address or name of remote host []: 10.10.10.1
Port number of the server [22]: 99
Destination file name [startup-config]: old_running
User name to login remote host: sburgess
Password to login remote host:
324