Dell PowerEdge FX2/FX2s - Manual (Page 445)

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface.
Syntax storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [packets_per_second in] command.
Parameters
packets_per_se
cond Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Command
Modes INTERFACE (conf-if-interface-slot/port)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information This command is available only in PMUX mode.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on the interface.
Syntax storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Command
Modes INTERFACE (conf-if-interface-slot/port)
445