Dell PowerEdge FX2/FX2s - Manual (Page 235)

ssh
Open an SSH connection specifying the host name, username, port number and version of the SSH
client.
Dell Networking OS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound
SSH supports accessing the system through the management interface as well as through a physical
Layer 3 interface.
Syntax ssh {hostname | ipv4 address} [-| username | -p port-number|-v
{1|2}]
Parameters
hostname (OPTIONAL) Enter the IP address or the host name of the
remote device.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
-l username (OPTIONAL) Enter the keyword -l followed by the user
name used in this SSH session. The default is the user name
of the user associated with the terminal.
-p port-
number (OPTIONAL) Enter the keyword -p followed by the port
number. The range is from 1 to 65536. The default is 22.
-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#ssh 123.12.1.123 -l ashwani -p 5005 -v 2
username
Establish an authentication system based on user names.
Syntax username name [nopassword | {password | secret} [encryption-
type] password] [privilege level]
If you do not want a specific user to enter a password, use the nopassword
option.
To delete authentication for a user, use the no username name command.
Parameters
name Enter a text string for the name of the user up to 63
characters.
235