Dell PowerEdge FX2/FX2s - Manual (Page 38)

nvram Enter the keyword nvram to reset the NvRAM only.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
Restoring factory defaults deletes the existing startup configuration and all
persistent settings (stacking, fanout, and so forth).
When restoring all units in a stack, all the units in the stack are placed into stand-
alone mode.
When restoring a single unit in a stack, that unit placed in stand-alone mode. No
other units in the stack are affected.
When restoring units in stand-alone mode, the units remin in stand-alone mode
after the restoration. After the restore is complete, the units power cycle
immediately.
CAUTION: There is no undo for this command.
Example
Dell#restore factory-defaults stack-unit 0 clear-all
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* startup-config and all persistent settings (stacking,
fanout, etc.)*
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
Power-cycling the unit(s).
Dell#
Example
(NvRAM, all)
Dell#restore factory-defaults stack-unit all nvram
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* persistent settings (stacking, fanout, etc.) *
* All the units in the stack will be split into standalone
units. *
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
1 Success
38