Dell PowerEdge FX2/FX2s - Manual (Page 176)

pipe-number
Enter the number of the Port-Pipe number. The range is
from 0 to 0.
ip-address
mask [longer-
prefix]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only.
Enter the keyword longer-prefixes to view routes with a
common prefix.
detail
Enter the keyword detail to display the group index ID
used by the ecmp routes int he CAM.
member-info Enter the keyword member-info to display the group index
used by the ecmp, the number of egress ports (members) for
the ecmp, and the port details of each member. The detail
information under member-info will give the MAC address,
VLAN ID and gateway of every member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Displays the destination route of the index.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit.
1 indicates that a packet hitting this entry is forwarded to the
control processor, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
176