Interface managementethernet – Dell PowerEdge FX2/FX2s User Manual
Page 348
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface’s configuration does not
contain an IP address and enter the Port Channel Commands command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#exit#
Related
Commands
— configures a port channel.
interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port
Enter the keyword ManagementEthernet, then the slot
number (0) and port number zero (0).
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
9.4.(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
You cannot delete a Management port.
348