Dell PowerEdge FX2/FX2s - Manual (Page 23)

Server-Facing LAGs
The tagged VLAN membership of a server-facing LAG is automatically configured based on the server-
facing ports that are members of the LAG.
The untagged VLAN of a server-facing LAG is configured based on the untagged VLAN to which the
lowest numbered server-facing port in the LAG belongs.
NOTE: Dell Networking recommends that you configure the same VLAN membership on all LAG
member ports.
To restore the default auto-VLAN mode of operation (in which all ports are members of all 4094 VLANs)
on a port, enter the auto vlan command:
Dell(conf)# interface tengigabitethernet 0/2
Dell(conf-if-te-0/2)# auto vlan
The auto vlan command is applicable only in Standalone mode.
To get the default standalone mode configurations:
1. Delete the startup-config file and reboot the system.
2. Restore to factory default settings.
Where to Go From Here
You can customize the Aggregator for use in your data center network as necessary. To perform
additional switch configuration, do one of the following:
• For remote out-of-band management, enter the OOB management interface IP address into a Telnet
or SSH client and log in to the switch using the user ID and password to access the CLI.
• For local management using the CLI, use the attached console connection.
• For remote in-band management from a network management station, enter the VLAN IP address of
the management port and log in to the switch to access the CLI.
In case of a Dell Networking OS upgrade, you can check to see that an Aggregator is running the latest
Dell Networking OS version by entering the
show version command. To download a Dell Networking OS
version, go to http://support.dell.com.
Refer to the appropriate chapter for detailed information on how to configure specific software settings.
23