Interface vlan – Dell PowerEdge FX2/FX2s User Manual
Page 140
Example-Bulk
Configuration
Warning
Message
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/4 ,
tengig 0/7
, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example-
Interface Range
prompt with
Multiple Ports
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/3 - 5
Dell(conf-if-range-te-0/1-5)#
Example-
Interface Range
prompt
Overlapping
Port Ranges
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/1 - 5
Dell(conf-if-range-te-0/1-5)#
Only VLAN and port-channel interfaces created using the interface vlan and
vlan tagged commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature
of the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical, and port-channel interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN or port-channel, only those respective interfaces
should be configured in a particular range.
Example-Single
Range Bulk
Configuration
Dell(conf)# interface range tengigabitethernet 0/1 - 5
Dell(conf-if-range-te-0/1-5)# no shutdown
Dell(conf-if-range-te-0/1-5)#
Example-
Multiple Range
Bulk
Configuration
with VLAN and
port channel
The following example shows how to use commas to add VLAN and port-channel
interfaces to the range.
Dell(conf-if)# interface range tengigabitethernet 0/1 - 5,
vlan 2 - 10, port-channel 1 - 25
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)#
Related
commands
show config (from INTERFACE RANGE mode)
— Shows the bulk configuration
interfaces.
— Displays a summary of interface information.
interface vlan
Configure the default VLAN to enable Static or DCHP IP configuration
Syntax
interface vlan def-vlan-id
140