Dell PowerEdge FX2/FX2s - Manual (Page 141)

Parameters
def-vlan-id Enter 1 for the default VLAN.
Defaults Not configured
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
This command is applicable only for the default VLAN. For all other VLANs, the
following error message displays:
Dell(conf)#int vlan 2
Error: Command allowed only for default Vlan.
Dell(conf)#
For more information about VLANs and the commands to configure them, refer to
Virtual LAN (VLAN) Commands .
Example
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Related
commands show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
monitor interface
Monitor counters on a single interface or all interfaces on a stack unit. The screen is refreshed every five
seconds and the CLI prompt disappears.
Syntax monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the management port, enter the keyword
managementethernet followed by the slot (0) and the
port (0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. The range is from 1 to
128.
141