Dell PowerEdge FX2/FX2s - Manual (Page 455)

back-up destination
Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer to be used as
the endpoint of the VLT backup link for sending out-of-band hello messages.
Syntax back-up destination {[ipv4–address] | [ipv6 ipv6–address]
[interval seconds]}
Parameters
ipv4–address Enter the IPv4 address of the backup destination.
ipv6 Enter the keyword ipv6 then an IPv6 address in the
X:X:X:X::X format.
interval
seconds Enter the keyword interval to specify the time interval to
send hello messages. The range is from 1 to 5 seconds. The
default is 1 second.
Defaults 1 second
Command
Modes VLT DOMAIN
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
clear vlt statistics
Clear the statistics on VLT operations.
Syntax clear vlt statistics [arp | domain | igmp-snoop | mac |
multicast | ndp]
Parameters
domain Clear the VLT statistics for the domain.
multicast Clear the VLT statistics for multicast.
mac Clear the VLT statistics for the MAC address.
arp Clear the VLT statistics for ARP.
igmp-snoop Clear the VLT statistics for IGMP snooping.
ndp Clear the VLT statistics for NDP.
Command
Modes EXEC
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
455