Dell PowerEdge FX2/FX2s - Manual (Page 162)

x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
222 Inactive U TenGig 1/22
Dell(conf-if-vl-222)#
Dell#
Related
Commands
interface vlan — Configures a VLAN.
shutdown
Disable an interface.
Syntax shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
The show tdr command marks a physical interface as unavailable for traffic. To
discover if an interface is disabled, use the show ip interface command.
Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the show tdr command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, you must enter no show tdr on the port channel interface
and at least one interface within that port channel.
The show tdr and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
vlan tagged —Test the condition of copper cables on 100/1000/10G Base-T
modules.
interface vlan — Creates a VLAN.
show ip interface — Displays the interface routing status. Add the keyword brief
to display a table of interfaces and their status.
162