Dell PowerEdge FX2/FX2s - Manual (Page 435)

• SNMP v3 informs are not currently supported with IPv6 addresses.
• If you are using access control lists (ACLs) in an SNMP v3 configuration, group ACL overrides user ACL
if the user is part of that group.
• SNMP operations are not supported on a virtual local area network (VLAN).
snmp-server enable traps
Enable SNMP traps.
Syntax snmp-server enable traps { snmp [linkdown | linkup] | stack}
To disable traps, use the no snmp-server enable traps [notification-
type] [notification-option] command.
Parameters
snmp Enter the keyword snmp to enable SNMP traps.
For the snmp traps, enter one of the following optional
parameters:
• linkdown — to enable linkdown trap.
• linkup — to enable linkuptrap
stack Enter the keyword stack to enable stacking role change
traps.
Defaults Not enabled.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
Dell Networking OS supports up to 16 SNMP trap receivers.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax snmp-server host ip-address | ipv6-address
To remove the SNMP host, use the no snmp-server host ip-address
command.
Parameters
ip-address Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
435