Dell PowerEdge FX2/FX2s - Manual (Page 447)

Where port-range and port-channel-range specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
tengigabitethernet 1/1-2,5,9,11-12 port-
channel 1-3,5. A comma is required to separate each port
and port-range entry.
uplink-state-
group group-id Re-enables all UFD-disabled downstream interfaces in the
group. The valid group-id values are from 1 to 16.
Defaults A downstream interface in a UFD-disabled uplink-state group is also disabled and is
in a UFD-Disabled Error state.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
• downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
debug uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands clear ufd-disable — re-enables downstream interfaces that are in a UFD-Disabled
Error state.
447