Dell PowerEdge FX2/FX2s - Manual (Page 150)

Line Description
Output Statistics: Displays output statistics sent out of the interface including:
• Number of packets, bytes, and underruns out of the
interface
– packets = total number of packets
– bytes = total number of bytes
– underruns = number of packets with FIFO underrun
conditions
• Number of Multicast, Broadcast, and Unicast packets:
– Multicasts = number of MAC multicast packets
– Broadcasts = number of MAC broadcast packets
– Unicasts = number of MAC unicast packets
• Number of throttles and discards packets::
– throttles = packets containing PAUSE frames
– discarded = number of packets discarded without
any processing
Rate information... Estimate of the input and output traffic rate over a
designated interval (30 to 299 seconds). Traffic rate is
displayed in bits, packets per second, and percent of line
rate.
Time since... Elapsed time since the last interface status change
(hh:mm:ss format).
Usage
Information
The interface counter “over 1023-byte pkts” does not increment for packets in the
range 9216 > x <1023.
The Management port is enabled by default (no shutdown). If necessary, use the
ip address command to assign an IP address to the Management port.
Example
(ManagementE
thernet)
Dell#show interface managementethernet ?
0/0 Management Ethernet interface number
Dell#show interface managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Current address is 00:1e:c9:f1:00:05
Pluggable media not present
Interface index is 235159752
Internet address is 10.11.209.87/16
Mode of IP Address Assignment : MANUAL
DHCP Client-ID: mgmt001ec9f10005
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 100 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d4h57m
Queueing strategy: fifo
Input 3448753 packets, 950008323 bytes, 3442163 multicast
Received 0 errors, 0 discarded
150