Dell PowerEdge FX2/FX2s - Manual (Page 164)

Parameters
interface Enter the keyword TenGigabitEthernet followed by the
slot/port information for the 100/1000/10GBase-T Ethernet
interface.
Defaults none
Command
Modes EXEC
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test tengigabitethernet 0/2
%Error: Interface is disabled TenGIG 0/2
Related
Commands show tdr — Displays the results of the TDR test.
vlan tagged (CMC)
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax vlan tagged [vlan-id]
To remove a tagged interface from a VLAN, use the no vlan tagged vlan-id
command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
If the interface belongs to several VLANs, you must remove it from all VLANs to
change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
When two or more ports configured for VLANs form a LAG, the resulting LAG is a
tagged member of all the configured VLANs and an untagged member of the VLAN
to which the port with the lowest port ID belongs.
164