Dell PowerEdge FX2/FX2s - Manual (Page 247)

23
Storm Control
The Dell Networking OS storm control feature allows you to limit or suppress traffic during a traffic storm.
NOTE: When iSCSI storage devices are detected on the server-ports, storm-control is disabled on
the those ports. When the iSCSI devices are off the ports, storm-control is enabled again.
The storm control commands are:
• io-aggregator broadcast storm-control
• show io-aggregator broadcast storm-control status
io-aggregator broadcast storm-control
Rate-limit the traffic storm to 1 Gbps.
Syntax io-aggregator broadcast storm-control
To disable storm control, use the no io-aggregator broadcast storm-
control command.
Defaults Enabled
Command
Modes
• CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information This command is not available in PMUX mode.
show io-aggregator broadcast storm-control status
Shows if storm control is enabled or disabled. If enabled, displays information on the rate limit value.
Syntax show io-aggregator broadcast storm-control status
Command
Modes
• EXEC Privilege
247