Dell PowerEdge FX2/FX2s - Manual (Page 343)

Defaults Dell Compellent disk arrays are not detected.
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is
monitored.
Syntax iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters
tcp-
port-2...tcpport
- 16 Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860,
3260.
ip-address (Optional) Enter the ip-address that the iSCSI monitors. The
ip-address specifies the IP address of the iSCSI target.
Defaults 860, 3260
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or
multiple commands.
When you use the no iscsi target port command and the TCP port you wish
to delete is one bound to a specific IP address, the IP address value must be
included in the command.
Interfaces
The commands in this chapter are supported by Dell Networking Operating System (OS).
343